CISCO交换机端口镜像配置
在思科交换机上做镜像端口1、镜像配置配置镜像端口>enable#conf t(config)#monitor session 1 source interface fastethernet 5/48最后可接参数both 双向监控rx 接收tx 发送配置目的端口monitor session 1 destination interface fastethernet 5/1(config)#ex
·
在思科交换机上做镜像端口
1、镜像配置
配置镜像端口
>enable
#conf t
(config)#monitor session 1 source interface fastethernet 5/48
最后可接参数
both 双向监控
rx 接收
tx 发送
配置目的端口
monitor session 1 destination interface fastethernet 5/1
(config)#exit
#wr
查看配置结果
Switch#show monitor
2.删除镜像端口
(config)#no monitor session 1
更多推荐
已为社区贡献1条内容
所有评论(0)